WTB: A body 8 3/4 rear end

[CrazyPete]

im looking for a complete set up for my dart with the big bolt pattern complete with brakes if possible thanks also im in need of a front disc set up as well

[71blueduster]

I think there are some on forabodiesonly.com but you probably want something close by. I think all a-body 8-3/4's were small bolt pattern as well, unless someone already upgraded it.

[CrazyPete]

yeah i found a few on there but there well over 1k with shipping

[71blueduster]

They're tough to find and when you do they are expensive. I've got one, but I plan on using it.

[CrazyPete]

i may email DR. Diff and see what he can do

[no318]

PM sent

[spoolinhard]

I have one. $250. Does not have 3rd member. everything else is there. Needs to be gone through and cleaned up.

[CrazyPete]

I have one. $250. Does not have 3rd member. everything else is there. Needs to be gone through and cleaned up.

not bad can u get me measurements and is it complete minus the 3rd member?

[CrazyPete]

PM sent

thanks kev

[spoolinhard]

I have one. $250. Does not have 3rd member. everything else is there. Needs to be gone through and cleaned up.

not bad can u get me measurements and is it complete minus the 3rd member?

It is disassembled. drums assemblies and axles are all there. Dont know about brake lines. I can get you a measurement if you still want it. Came out from under a duster. No doubt that it is an A body.

[CrazyPete]

sounds good

[spoolinhard]

Didnt get a chance to measure it this weekend when I was around it. Will do it for sure this next weekend.
sorry

[CrazyPete]

im in no big hurry

[spoolinhard]

backing plate to backing plate roughly 51 inches.

[CrazyPete]

ok thanks i'll check out my dart this week and let u know