bb e body guys ? for you

[440forPOWER]

Hello, is anyone running a set of the tti 1 7/8 inch headers in a bb ebody with power steering? If so how is the fit? Can you get at the plugs on the drivers side at all? I really want to keep the hp manifolds but it just gives up way to much hp. Thanks in advance

[CrazyPete]

they fit changing plugs is always a pain with headers

[440forPOWER]

Hello crazypete, just looking at the motor with the manifolds it doesn't look like headers would be fun at all. If it didn't have power steering it might be a bit easier. I was hoping someone on here might have a set on I could check out. Might have to try and hit a car show or two if there are any left this year. Thanks :Thumb:

[CrazyPete]

i have a ton of pics if u need them

[6PackCuda]

That's what I've got on my Cuda. The plugs are a little bit of a pain to get in and out but not too bad. Actually it's a little easier to get some of them from underneath.

http://i112.photobucket.com/albums/n194/dwamboldt/other/013.jpg
http://i112.photobucket.com/albums/n194/dwamboldt/other/014-1.jpg

[440forPOWER]

Thanks 6Packcuda !!!! Thats just what I was looking for. Looks like there is more room than I have with the hp manifold.. Almost forgot, how is the ground clearance with those? Thanks again :Thumb:

[6PackCuda]

There's plenty of ground clearance. They hang down a little lower than stock pipes but you would have to try pretty hard to get them to scrape.